Citroen C5 Aircross Wiring Harness

Full loom replacement is rare and expensive. AE Wiring in Port Elizabeth manufactures Citroen harnesses locally. In practice we repair damaged sections with soldered splices and heatshrink rather than replace — request a free quote for a diagnosis.

On the C3, a leaking washer bottle or a failed coolant temp sensor can drip onto the ECU connector in the engine bay. Blocked bulkhead drains flood the footwell loom. Bonnet seal failure lets rain into the scuttle area. All are common SA complaints.

A chafed ABS wheel speed sensor loom is the most common cause we see — the wheel moves the wire, insulation wears through and the signal shorts. Intermittent because it only grounds when the loom flexes the right way. Inspect where the loom crosses the suspension arm.

Yes and it should always be the first approach. A good auto-electrician solders, heatshrinks and re-sleeves damaged sections for a fraction of full-harness cost. Full replacement is only justified after fire damage or flooding that corrodes the entire loom.

Somewhere in a damp stretch of loom, water is shorting a wire to earth. The usual suspects are under the battery tray, the bulkhead connector sitting behind the airbox, and on hatchbacks the rubber boot carrying the tailgate loom. Work out which circuit the blown fuse protects, then go over that loom looking for damp.